SPA3 legacy servo power amplifier

• SPA3 can be used with UCC T3 PLUS, UCC T5 and UCC S3
• The high power capability combined with a compact enclosure enables use of the SPA3 across a wide range of machines
• The SPA3 CMM amplifier has the capability to:
• • power three axes of a CMM
  • accept input signals from air pressure, crash detection and all axis inner and outer travel limit switches (when used with UCC T3 PLUS, UCC T5 and UCC S3)
  • accept two uncommitted general purpose input signals and generate one uncommitted general purpose output signal (when used with UCC T3 PLUS, UCC T5 and UCC S3)
  • provide a +24 V supply for use by the CMM switches (when used with UCC T3 PLUS, UCC T5 and UCC S3)
  • support the MCUlite-2 joystick, and also support the MCU5 and MCU W (when used with UCC T3 PLUS, UCC T5 and UCC S3)
  • provide power output of up to 800 W continuous and 960 W for up to 1 second
  • set the voltage of each axis independently allowing differing motor voltages to be used
  • support dc motors in the range 12 V to 80 V and currents up to 10 A
  • support encoder / tacho or linear encoders (torque mode) for velocity feedback
  • provide category 2 E-STOP.

Technical specification

■ Standard specification

- Not available

* Output voltage should approximately match input voltage