Navigation
UCC T3 (UCCFusion) legacy controller
Entry level combined controller and amplifier
Used on 3-axis DCC touch-trigger CMMs
- Scanning, temperature compensation and PH9 control is not supported
- PC communication is via USB
- 1U high and 19 inches wide enclosure can be rack mounted or stand alone on a flat surface
- In-built touch trigger interface
- External power supply required; either from Renishaw or OEM
- Initial supply will operate between 24 V - 60 V
- Use of an external PSU allows the most economical solution to match the power requirements of the CMM and motors
- UCCsuite version 4.4.4 or greater is required which can be downloaded from CMM support at www.renishaw.com
Minimum PC specification
- 1 GHz Pentium 3 processor
- 256Mb RAM
- 2 GB hard drive
- Internet Explorer 6
Operating system compatibility
- Windows XP Professional
- Windows Vista
- Windows 7
![UCC T3 rear panel](/cmmsupport/knowledgebase/media/img/en/21f5a8c0ace740a1a9f8622dd83da5d4.jpg)