Stran trenutno ni na voljo v vašem jeziku. Lahko si ogledate strojni prevod, ustvarjen s storitvijo Google Translate. Te storitve ne zagotavljamo mi in rezultatov prevoda nismo preverili.
Za dodatno pomoč se lahko obrnete na nas.
Training in the UK
Training options
Renishaw recognises that training requirements vary according to territory and industry, and as a result provides a variety of training options to help you exploit the full potential of your laser and ballbar systems.
Renishaw can provide training both in-house at our high quality training facilities or at your site.
Training in-house takes place in a dedicated lecture room with AV facilities as well as on a selection of modern machine tools including multi-axis machines in the adjacent demonstration rooms.
All of our training courses are performed by our vastly experienced engineers who have dedicated themselves to promoting best practices across the industry.
QC20 ballbar training
The course content will cover:
- Familiarisation of components in the QC20 ballbar kit
- Planning a ballbar test
- The effects of temperature
- Machine tool axis conventions
- Understand the difference between configuration and advanced mode
- Interpretation of captured data
- Diagnosis and corrective actions
- Ballbar accessories
- 5-axis ballbar verification
XK10 alignment laser training
The course content will cover:
- Familiarisation of components in the XK10 alignment system
- Planning a test
- Understand the different measurement modes
- Alignment process
- Geometric measurement: straightness, squareness, parallelism, flatness and level
- Rotational measurement: straightness, coaxiality and spindle direction
- Data capture modes
- Interpretation of captured data
XL-80 laser training
The course content will cover:
- Familiarisation of the components in the XL-80 laser system
- Planning a test
- Understanding different measurement modes
- Alignment process
- Linear measurement
- Angular measurement
- Straightness measurement
- Squareness measurement
- Flatness measurement
- Rotary measurement
- Interpretation of captured data
- Error correction
XM-60 multi-axis calibrator training
The course content will cover:
- Familiarisation of the components in the XM-60 multi-axis calibrator system
- Planning a test
- Understand the different measurement modes
- Alignment process
- Data capture modes
- Rotary measurement
- Interpretation of captured data
- Diagnosis and corrective actions
- Error correction options
Course objectives
- To provide you with the skills and confidence necessary to perform any measurement data capture on a chosen machine using a Renishaw calibration system.
- To allow you to practice setting up the calibration equipment to capture data and provide feedback.
- To provide initial support and coaching to allow you to adapt these new skills to the workplace.