MCU references and associated documents

It is recommended that the following documentation be referred to when installing an MCU.

Renishaw documents

Installation guide: SPA3-2 (H-1000-5364)

Installation guide: SPA3-2 (H-1000-5364)

No description available
[1.5MB]
Installation guide: UCC T5 (H-1000-7573)

Installation guide: UCC T5 (H-1000-7573)

The UCC T5 must be used in conjuction with a Renishaw SPA3. Setup and commisioning should be completed through Renishaw's UCCassist-2 software. The UCC T5 has replaced the UCC2 and 5-axis daughtercard. It also replaces the TEC card and provides support for 16 channels of temperature compensation. The UCC T5 uses an external power supply and manges full control of the PH20 head, CMM and probe signals and communicates with the CMM's computer.
[1.4MB]
Installation guide: UCC T3-2

Installation guide: UCC T3-2

No description available
[1.2MB]
Installation guide: UCC T3 PLUS and UCC S3 CMM controller

Installation guide: UCC T3 PLUS and UCC S3 CMM controller

No description available
[1.5MB]
Installation guide: UCC S5 REVO-2 CMM controller (H-1000-7598)

Installation guide: UCC S5 REVO-2 CMM controller (H-1000-7598)

No description available
[1.5MB]

External documents

National and international standards including the following may be applicable to the finished machine or installation:

BS EN ISO 12100:2003 parts 1 and 2 Safety of Machinery - Basic Concepts, General Principles for Design.

BS EN 60204-1:2006 Safety of machinery - Electrical equipment of machines - Part 1: General requirements.

CMM support

CMM probes, software and retrofits