Bu sayfa şu anda sizin dilinizde mevcut değildir. Google'ın Çeviri sistemini kullanarak
otomatikleştirilmiş çeviriye
ulaşabilirsiniz. Bu hizmeti sağlamaktan sorumlu değiliz ve çeviri sonuçları tarafımızdan kontrol edilmemiştir.
Eğer daha fazla yardıma ihtiyaç duyarsanız lütfen
bizim ile temasa geçiniz.
Questions on Renishaw contact tool setters
Below is a list of frequently asked questions for Renishaw's contact tool setting probes.
Q: How do I measure an off-center tool without approximate tool length input
A: You can't, an approximate tool length is always needed.
Q: How do I measure dia. 0.5 mm small tool?
A: By slowing down the measuring feedrate.
Q: How do I change approach and measuring feedrate?
A: You need to amend the macro software – Contact Renishaw's technical support team for more details.
Q: Can I just do length calibration?
A: No you can't, the calibration cycle will check both length and diameter.
Q: When does the calibration cycle run?
A: Once initial set-up has been completed, the automatic calibration cycle can be run at intervals that suit the machining process requirements.
Q: How long will the batteries in my OTS last?
A: The battery life is listed in the OTS Data sheet.
Q: How do I turn on/off the OTS?
A: The OTS operates using optical on/optical off mode.
If your question hasn't been answered, please contact Renishaw's technical support team.